Parallel MPI application to recursively copy files and directories.

dcp is a file copy tool in the spirit of cp(1) that evenly distributes work across a large cluster without any centralized state. It is designed for copying files that are located on a distributed parallel file system.


-i, --input FILE

Read source list from FILE. FILE must be generated by another tool from the mpiFileUtils suite.

-p, --preserve

Preserve permissions, group, timestamps, and extended attributes.

-s, --synchronous

Use synchronous read/write calls (open files with 0_DIRECT)

-S, --sparse

Create sparse files when possible (non-functioning).

-v, --verbose

Run in verbose mode.

-h, --help

Print a brief message listing the dcp(1) options and usage.


If a long-running copy is interrupted, one should delete the partial copy and run dcp again from the beginning. One may use drm to quickly remove a partial copy of a large directory tree.

To ensure the copy is successful, one should run dcmp after dcp completes to verify the copy, especially if dcp was not run with the -s option.


  1. To copy dir1 as dir2:

mpirun -np 128 dcp /source/dir1 /dest/dir2

  1. To copy contents of dir1 into dir2:

mkdir /dest/dir2 mpirun -np 128 dcp /source/dir1/\* /dest/dir2

  1. To copy while preserving permissions, group, timestamps, and attributes:

mpirun -np 128 dcp -p /source/dir1/ /dest/dir2


Using the -S option for sparse files does not work yet at LLNL. If you try to use it then dcp will default to a normal copy.

The maximum supported file name length for any file transferred is approximately 4068 characters. This may be less than the number of characters that your operating system supports.


The mpiFileUtils source code and all documentation may be downloaded from <https://github.com/hpc/mpifileutils>